This documentation is relevant to WMWifiRouter version 1.20 and newer, and has been last updated to reflect the changes in version 1.25.
Interface detection
Setup wizard - Interface detectionThe setup wizard will start with trying to detect the available interfaces (network cards) on your device. It will ask you to turn on wifi and bluetooth for this, as on some devices these interfaces are not detectable unless they are turned on. On a small number of devices it may be even be necessary to connect your device to your computer through USB as well.
Should WMWifiRouter not detect your wifi card, it will present you with a list of unknown interfaces for you to choose from. This seldom happens, though.
As part of the interface detection routine, it will also examine your available cellular connections. If there is only one cellular connection available, it will be selected automatically. If there are multiple, WMWifiRouter will present you with a list of cellular connections to choose from. It will try to detect the preferred connection and if it was able to do so, preselect it in the list.
After you have run the setup wizard, you can always change the cellular connection by going to Options, Configuration, Cellular connection .
Installation
Upgrading
Uninstallation
Setup wizard
Interface detection
Wifi network
Main screen
Cellular to Wifi
Cellular to USB
Cellular to Bluetooth
Wifi to USB
USB to Wifi
Exit
Connected screen
Status
Overview
Source
Target
NAT
NAT mappings
Disconnect
Options
Tools
Reset all settings
Show log
USB
Switch mode
Bluetooth
Switch mode
Switch discoverable
Wifi
Power control
Switch connection mode
Configuration
Cellular connection
Wifi network
IP range
Battery
Keep-Alive
Advanced
Port mappings
About
License
Exit