This documentation is relevant to WMWifiRouter version 1.20 and newer, and has been last updated to reflect the changes in version 1.25.
Installation
InstallationThere are two options for installation:
- EXE (ActiveSync) installer, to be used from your personal computer
- CAB installer, to be used directly on your device
To install using the EXE-based installer, make sure your device is connected to your computer by USB cable or Bluetooth and run the EXE on your personal computer. This will install the program on your device.
Note that using the EXE installer, you can input your license code (if you have one) directly into the installer. The installer will remember the license code for the next time you use it to install WMWifiRouter.
To install using the CAB-based installer, download or copy the CAB file to your device and run it on your device itself to install it.
On some devices, wifi has to be turned on before starting the installation to install successfully.
Note that if you are a user of WMWifiRouter v1.11 or earlier, you should uninstall that version before installing the new version.
Making a full backup of your device before installing WMWifiRouter (or any other software) is advised.
Sub-articlesUpgrading
Uninstallation
Installation
Upgrading
Uninstallation
Setup wizard
Interface detection
Wifi network
Main screen
Cellular to Wifi
Cellular to USB
Cellular to Bluetooth
Wifi to USB
USB to Wifi
Exit
Connected screen
Status
Overview
Source
Target
NAT
NAT mappings
Disconnect
Options
Tools
Reset all settings
Show log
USB
Switch mode
Bluetooth
Switch mode
Switch discoverable
Wifi
Power control
Switch connection mode
Configuration
Cellular connection
Wifi network
IP range
Battery
Keep-Alive
Advanced
Port mappings
About
License
Exit